MACHINING OF POROUS MATERIALS

UDC 620.179.118

Author:

Tolstenko A.V., Ph. D. (Tech.) (DSAEU)

Abstract.

The article describes mechanical treatment factors impacting on a degree of surface roughness of the cast porous materials.

Special attention focuses on such factors as cutting speed, cross feed, type of the cooling lubricants (for mechanical treatment by cutting and milling operations), cutter speed, factual speed of the table feed per minute.

Surface roughness of the samples was measured by a profile meter (model 296). A model of the first order was used for evaluating degree of the above factors’ impact and for mathematic describing of the results obtained. It is stated that spindle and cutter speed impacts mostly on the surface roughness of cast porous materials.

Keywords:

surface roughness Ra, milling, treatment by cutting, porous materials

References:

  1. Shapovalov, V.I. (2013), Legirovaniye vodorodom [Alloying hydrogen], Zhurfond, Dnepropetrovsk, Ukraine.
  2. Shapovalov, V.I. (1982), Vliyaniye vodoroda na strukturu i svoystva zhelezo-uglerodistykh splavov [Influence of hydrogen on the structure and properties of iron-carbon alloys], Metallurgiya, Moscow, USSR.
  3. Karpov, V.V., Gubenko, S.I. and Karpov, V.Yu. (2012), “Formation of gasars casts with complex structure”, Stroitel’stvo, materialovedeniye, mashinostroyeniye, no. 64, pp. 326-328.
  4. Shapovalov, V.I. (2007), “Prospective Applications of Gas-Eutectic Porous Materials (Gasars) in USA”, Science Forum, Switzerland, pp. 1183-1187.
  5. Banhart, J. (2001), “Manufacture, characterisation and application of cellular metals and metal foams”, Progress in Material Science, vol. 46, pp. 559-632.
  6. Vysotskiy, A.S. (2003), “Anti-friction self-lubricating materials based on gas-crystalline compositions”, Tezi mízhnarodnoí̈ konferentsíí̈, Mashinobuduvannya ta metaloobrobka – 2003 [Mechanical engineering and metal working – 2003], Kirovograd, Ukraine, April 17-19.
  7. Karpov, V.Yu., Tolstenko, A.V. and Bedin, A.S. (2012), “Roughness of cast porous materials (gasars) in cutting”, Novyye materialy i tekhnologii v mashinostroyenii, no. 15, pp. 64-65.
  8. Karpov, V.Yu., Tolstenko, A.V., Bedin, A.S., Bib, A.S. and Kharchenko, B.G. (2013), “Roughness of cast porous materials (gasars) in milling”, Novyye materialy i tekhnologii v mashinostroyenii, no. 17, pp. 44-45.

About the author:

Tolstenko Alexandr Vasil’yevich, Candidate of Technical Science (Ph. D.), Associate Professor of Department «Reliability and repair of machinery», Dnepropetrovsk State Agrarian and Economic University (DSAEU), Dnepropetrovsk, Ukraine.

Attachments:
FileDescriptionFile size
Download this file (14.pdf)14.pdfMACHINING OF POROUS MATERIALS596 kB