Nadutyy V.P., Titov A.A. Experimental research of material deformed zone’s cross-section configuration in disintegrators influence on the zone’s thickness

Details

Parent Category: Geo-Technical Mechanics, 2016

Category: Geo-Technical Mechanics, 2016, Issue 127

 

Geoteh. meh. 2016, 127, 18-24

 EXPERIMENTAL RESEARCH OF MATERIAL DEFORMED ZONE’S CROSS-SECTION CONFIGURATION IN DISINTEGRATORS INFLUENCE ON THE ZONE’S THICKNESS

¹Nadutyy V.P., ²Titov A.A.

¹IGTM of NAS of Ukraine, ²State HEI “NMU”

UDC 621.926: 622.73

Abstract. The physical modeling of fine loose material deformation between two rigid surfaces of disintegrators is conducted. The granite particles of size -2+1 mm have been taken as working material. The experimental dependences of deformed zone thickness are obtained during compressing of material layer between parallel surfaces for different combinations of the zone's length and width. The character of dependences between zone’s thickness to radius ratio and zone’s length to radius ratio is sufficiently non-linear.The linear dependence for dimensionless complexes of deformed zone's thickness to radius ratio and the radius to the perimeter of minimal cross-section ratio is set. The results of work allow to determine the deformed zone parameters of disintegrators with working surfaces extended along one of directions, for example, jaw crushers or rod mills.
Keywords: disintegrator, crusher, mill, working surface, deformed zone, loose material.

REFERENCES

1. Kuhar, A.G. (1983), "About dependencies of grinding process in a vertical vibrational mill", Mineral dressing: Resp. int.-dep. sci.-res. col., no. 32, pp. 44-51.
2.Andreev, S.E., Perov, V.A. and Zverevich, V.V. (1980), Drobltniye, izmelcheniye I grokhocheniye poleznikh iskopayemykh [Crushing, grinding and screening of minerals], Nedra, Moscow, SU.
3. Trudy yevropeyskogo soveshchaniya po izmelcheniyu [Works of European meeting on grinding] (1966), Stroyizdat, Moscow, SU.
4. Antsiferov, A.V. and Titov, A.A. (2004), “Determination of nip angle for grinders of fine materials”, Vibrations in equipment and technologies, no. 1(33), pp. 28-30.
5. Revnivtsev, V.I., Denisov, G.A., Zarogatskiy, L.P. and Turkin, V.Y. (1992), Vibratsionnaya dezintegratsiya tverdykh materialov [Vibrational disintegration of hard materials], Nedra, Moscow, RU.
6. http://sgm-eng.ru/o-kompanii/articles/texnologiya-proizvodstva-kubovidnogo-Shhebenya.

About the authors:

Nadutyy Vladimir Petrovich, Doctor of Technical Sciences (D.Sc.), Professor, Head of Department of Geodynamic Systems and Vibration Technologies, M.S. Polyakov Institute of Geotechnical Mechanics under the National Academy of Science of Ukraine (IGTM NASU), Dnepropetrovsk, Ukraine, This email address is being protected from spambots. You need JavaScript enabled to view it. .

Titov Alexandr Alexandrovich, Candidate of Technical Sciences (Rh.D), Associate Professor in Department of Mining Machines and Engineering, State HEI “the National Mining University”, Dnepropetrovsk, Ukraine, This email address is being protected from spambots. You need JavaScript enabled to view it. .

• < Prev
• Next >